下载Odin3.07.zip
下载CF-Root for SGS3 v6.4
然后根据以下教程(懒得翻译中文):
How to install using: (desktop) ODIN
Short: unpack the ZIP download, you will end up with a TAR, flash this in ODIN as PDA, and optionally install and run Triangle Away afterwards to reset the flash counter. Beware that this should boot your device into recovery mode (for a few seconds to install SuperSU and CWM Manager) after flashing. Sometimes it doesn't, just flash it again in that case.
- Follow these instructions to the letter. Do not touch any buttons or checkboxes that are not listed below to touch!
- Unzip the attached Odin3-vX.X.zip file
- Download and unzip the CF-Root-SGS3-vX.X.zip file
- If you end up with a recovery.img and cache.img file, you've extracted twice. You need to end up with a .tar file - don't extract that one
- (USB) Disconnect your phone from your computer
- Start Odin3-vX.X.exe
- Click the PDA button, and select CF-Root-SGS3-vX.X.tar
- Put your phone in download mode (turn off phone, then hold volume-down + home + power to boot - if it asks you to press a button to continue, press the listed button, or run adb reboot download command)
- (USB) Connect the phone to your computer
- Make sure Repartition is NOT checked
- Click the Start button
- Wait for Android to boot
- Done (if it took you more than 30 seconds, you need practise!)





